System Error Messages - DURKOPP ADLER 745-34 Manual

7.5 System error messages

Error number
Error 600
Error 601
Error 602
Error 603
Error 604
Error 700
Error 701
Error 702
Error 703
Error 704
Error 710
Error 711
Error 720
Error 721
Error 722
Error 723
Error 725
Error 726
Error 727
92
Meaning
Air pressure inadequate or
non-existent
Left pedal pushed back
during sewing
Empty bobbin
Thread breakage
Light barrier (s20) for material
removal not active
Folder not up
Folder not down
Folder not vertical
Folder not slanting
Folder not on the piped table
Feed-clamp limit switch active
Corner-blade block limit switch
active
Light-barrier flap-scanning error
Flap placed in front of front
positioning point
Part of flap outside maximum
sewing area (behind rear
positioning point)
Fluff on flap edge
Flap angle is too great
Flap too large or reflecting foil dirty
or defective
Stop section insufficient for the flap
angle
Remedy
Turn up and stabilise compressed air
Tto clear this error the left pedal must be
operated again; the feed clamp then
moves to its rear position
Insert full bobbin
Re-thread thread
Adjust light barrier (s20) for material
removal
Correct the folder setting (mechanical
impact; check switch S17)
Correct the folder setting (mechanical
impact; check switch S17)
Correct the folder setting (mechanical
impact; check switch SC003)
Correct the folder setting (mechanical
impact; check switch SC004)
Correct the folder setting (mechanical
impact; check switch SC002)
Check material feed and limit switch S25
Check corner-blade drive and limit switch
S26
Inspect reflecting foil; check light-barrier
alignment
Position flap correctly
Inspect flap size; insert flap correctly
Insert flaps with smooth edges; inspect
reflecting foil
Inspect flap angle; check light-barrier
alignment
Inspect flap size and reflecting foil
Reduce slide-in speed