Sewing Unit With Two Light Barriers, Left Or Right Flap Positioning - DURKOPP ADLER 745-34 Manual

6.3.4.3 Sewing unit with two light barriers, left or right flap positioning

3 2
Caution: danger of injury
During the reference run the feed clamps move forwards or back and
forth several times.
Do not reach into the path of the feed clamps.
Folding station must be swinged out
–
Press function key "F3".
The reference run is carried out.
–
Press "8" and select the clamp position (see page 33).
Hint:
The light barriers must be aligned to the clamp position
–
Press "9".
The flap clamp opens.
–
Press function key "F4".
The needles are switched on.
–
Turn the hand-wheel in the direction of rotation to lower the
needles to about 2 mm above the material.
–
Insert the straight-pocket template 1 so that line 2 points to the left
needle and is parallel to the right feed clamp. Both reflecting foils
must be covered.
–
Press "9" to close the flap clamp.
–
Stick the left, proud side of the template to the clamp with a strip of
adhesive tape 3.
–
Press function key "F4".
The needles are switched off.
–
Turn the hand-wheel in the opposite direction to the direction of
rotation to bring the needle back to upper dead center.
1
57