Setting The Piping Knife Reference Position - DURKOPP ADLER 745-34 Manual

6.3.12.2 Setting the piping knife reference position

Code
–
Select the symbol
–
Start the program with the OK-key.
The display shows the input prompt for the code number.
Enter the code number "25483" via the numeric keyboard.
The screen menu for the piping knife reference position appears.
–
Loosen 4 screws and remove the lower cover at the piping cutter.
Select icon ... , enter the correction value "Piping knife reference"
via the numeric keyboard and confirm with the OK-key. The cutting
unit moves to the entered reference position.
Set the reference position in such a way that the distance between
roller guide 1 and plate 2 is 0.7 +/- 0.2 mm (measure with feeler
gauge).
–
Quit the menu (key F1), move the cutting unit by 120 mm (see
chapter 6.3.12.1 "Checking the step motor") and check the
distance between the roller guide and the plate at the opposite.
–
Fasten the lower cover at the piping cutter again.
with the cursor keys "ï" and "ð"
1 2
73