Centre blade
Centre blade
Entry: on/off
CAUTION:
Switching off the centre blade automatically switches off
the corner blades too.
However, switching the centre blade back on does not
automatically switch the corner blades back on again.
They must be switched on separately.
Centre-blade rpm
Entry: 1700...3000 [rpm]
Select with the "ñ" or "ò" keys.
+
Adjusting the centre-blade incision at the seam start
-
Changing this value carries out the
fine adjustment of the centre-blade incision at the
seam start.
Entry: - 9.9 ... + 9.9
+
Adjusting the centre-blade incision at the seam end
Entry: - 9.9 ... + 9.9
0 = no adjustment
+ = switch on centre blade
sooner
- = switch on centre blade
later
0 = no adjustment
+ = switch off centre blade
sooner
- = switch off centre blade
later
25