No material feed after corner incision
Material feed/ Stacker position
After the corner incision the
feed clamps transport the material to the set
position.
Entry: 001 - 100 [mm]
Hint:
The smaller the entry, the further the carriage
moves to the rear.
1
= rear position
100
= cutting position
Carriage return with material feed
After the corner incision the feed clamps
automatically transport the material back to the
positioning area.
Hint:
The icon is only active when the stacker/smoother
is switched off.
Info line:
Return to insertion position
Carriage return to stand-by position
measured from the rear reference switch
Entry: 001 - 515 [mm]
No carriage return
31