Manually Assign A Wep Key - ZyXEL Communications P-660HW-Tx v3 Series User Manual

5.3.2 Manually Assign a WEP Key

Choose Manually assign a WEP key to setup WEP Encryption parameters.
Figure 28 Manually Assign a WEP key
The following table describes the labels in this screen.
Table 18 Manually Assign a WEP key
LABEL
Key
Back
Next
Exit
Click Apply to save your wireless LAN settings.
5
Figure 29 Wireless LAN Setup 3
P-660HW-Tx v3 Series User's Guide
DESCRIPTION
The WEP keys are used to encrypt data. Both the ZyXEL Device and the
wireless stations must use the same WEP key for data transmission.
Enter any 5 or 13 ASCII characters, or 10 or 26 hexadecimal characters
("0-9", "A-F") for a 64-bit or 128-bit WEP key respectively.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
Chapter 5 Internet and Wireless Setup Wizard
95