The Address Mapping Screen - ZyXEL Communications P-660HW-Tx v3 Series User Manual

Chapter 9 Network Address Translation (NAT)

9.4 The Address Mapping Screen

Note: The Address Mapping screen is available only when you select Full Feature
in the NAT > General screen.
Ordering your rules is important because the ZyXEL Device applies the rules in the
order that you specify. When a rule matches the current packet, the ZyXEL Device
takes the corresponding action and the remaining rules are ignored. If there are
any empty rules before your new configured rule, your configured rule will be
pushed up by that number of empty rules. For example, if you have already
configured rules 1 to 6 in your current set and now you configure rule number 9.
In the set summary screen, the new rule will be rule 7, not 9. Now if you delete
rule 4, rules 5 to 7 will be pushed up by 1 rule, so old rules 5, 6 and 7 become new
rules 4, 5 and 6.
To change your ZyXEL Device's address mapping settings, click Network > NAT
> Address Mapping to open the following screen.
Figure 71 Network > NAT > Address Mapping
The following table describes the fields in this screen.
Table 47 Network > NAT > Address Mapping
LABEL
#
Local Start IP
Local End IP
Global Start
IP
178
DESCRIPTION
This is the rule index number.
This is the starting Inside Local IP Address (ILA). Local IP addresses are
N/A for Server port mapping.
This is the end Inside Local IP Address (ILA). If the rule is for all local IP
addresses, then this field displays 0.0.0.0 as the Local Start IP address
and 255.255.255.255 as the Local End IP address. This field is N/A for
One-to-one and Server mapping types.
This is the starting Inside Global IP Address (IGA). Enter 0.0.0.0 here if
you have a dynamic IP address from your ISP. You can only do this for
Many-to-One and Server mapping types.
P-660HW-Tx v3 Series User's Guide