The Reset Button; Using The Reset Button; The Wps Wlan Button - ZyXEL Communications P-660HW-Tx v3 Series User Manual

Table 1 LED Descriptions
LED
INTERNET
Refer to the Quick Start Guide for information on hardware connections.

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "1234". You can also use the

1.6.1 Using the Reset Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.

1.7 The WPS WLAN Button

You can use the WPS WLAN ON/OFF button on the back of the device to turn
the wireless LAN off or on. You can also use it to activate WPS in order to quickly
set up a wireless network with strong security.
P-660HW-Tx v3 Series User's Guide
COLO
STATUS DESCRIPTION
R
Green On The ZyXEL Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or
assigned by a DHCP server), PPP negotiation was
successfully completed (if used) and the DSL connection
is up.
Blinking The ZyXEL Device is sending or receiving IP traffic.
Red On The ZyXEL Device attempted to make an IP connection
but failed. Possible causes are no response from a DHCP
server, no PPPoE response, PPPoE authentication failed.
Off The ZyXEL Device does not have an IP connection.
Chapter 1 Introducing the ZyXEL Device
27