Wireless Lan Advanced Setup - ZyXEL Communications P-660HW-Tx v3 Series User Manual

Chapter 8 Wireless LAN
Table 33 Network > Wireless LAN > AP: WPA(2)
LABEL
Port Number
Shared Secret Enter a password (up to 31 alphanumeric characters) as the key to be

8.2.5 Wireless LAN Advanced Setup

Use this screen to configure advanced wireless settings. Click the Advanced
Setup button in the AP screen. The screen appears as shown.
See Section 8.8.2 on page 158
screen.
Figure 51 Network > Wireless LAN > AP: Advanced Setup
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN > AP: Advanced Setup
LABEL
RTS/CTS
Threshold
Fragmentation
Threshold
Output Power
Preamble
146
DESCRIPTION
Enter the port number of the external accounting server.
You need not change this value unless your network administrator
instructs you to do so with additional information.
shared between the external accounting server and the ZyXEL Device.
The key must be the same on the external accounting server and your
ZyXEL Device. The key is not sent over the network.
for detailed definitions of the terms listed in this
DESCRIPTION
Enter a value between 0 and 2432.
This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432.
Set the output power of the ZyXEL Device. If there is a high density of
APs in an area, decrease the output power to reduce interference with
other APs. Select one of the following Maximum, Middle or Minimum.
Select a preamble type from the drop-down list menu. Choices are Long,
Short or Dynamic. The default setting is Long. See the appendix for
more information.
P-660HW-Tx v3 Series User's Guide