ZyXEL Communications P-660HW-Tx v3 Series User Manual page 262

Chapter 16 Quality of Service (QoS)
See Appendix E on page 411
table describes the labels in this screen.
Table 76 Advanced > QoS > Class Setup: Edit
LABEL
Class Configuration
Active
Name
Interface
Priority
Routing Policy
WAN Index
Gateway
Address
Order
Tag Configuration
DSCP Value
262
for a list of commonly-used services. The following
DESCRIPTION
Select the check box to enable this classifier.
The text may consist of up to 20 letters, numerals and any printable
character found on a typical English language keyboard.
Select from which interface traffic of this class should come.
Select a priority level (between 0 and 7) or select Auto to have the
ZyXEL Device map the matched traffic to a queue according to the
internal QoS mapping table. See
information.
"0" is the lowest priority level and "7" is the highest.
Select the next hop to which traffic of this class should be forwarded.
Select By Routing Table to have the ZyXEL Device use the routing
table to find a next hop and forward the matched packets
automatically.
Select To WAN Index to route the matched packets through the
specified PVC. This option is available only when the WAN type is
ADSL.
Select To Gateway Address to route the matched packets to the
router or switch you specified in the Gateway Address field.
Select a PVC index number.
Enter the IP address of the gateway, which should be a router or
switch on the same segment as the ZyXEL Device's interface(s), that
can forward the packet to the destination.
This shows the ordering number of this classifier. Select an existing
number for where you want to put this classifier and click Apply to
move the classifier to the number you selected. For example, if you
select 2, the classifier you are moving becomes number 2 and the
previous classifier 2 gets pushed down one.
Select Same to keep the DSCP fields in the packets.
Select Auto to map the DSCP value to 802.1 priority level
automatically.
Select Mark to set the DSCP field with the value you configure in the
field provided.
Section 16.5.4 on page 267
P-660HW-Tx v3 Series User's Guide
for more