Manually Assign A Wpa-Psk Key - ZyXEL Communications P-660HW-Tx v3 Series User Manual

Chapter 5 Internet and Wireless Setup Wizard
Table 16 Wireless LAN Setup Wizard 2
LABEL
Next
Exit
Note: The wireless stations and ZyXEL Device must use the same SSID, channel ID
and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is
enabled) for wireless communication.
This screen varies depending on the security mode you selected in the previous
4
screen. Fill in the field (if available) and click Next.

5.3.1 Manually Assign a WPA-PSK key

Choose Manually assign a WPA-PSK key in the Wireless LAN setup screen to
set up a Pre-Shared Key.
Figure 27 Manually Assign a WPA-PSK key
The following table describes the labels in this screen.
Table 17 Manually Assign a WPA-PSK key
LABEL
Pre-Shared
Key
Back
Next
Exit
94
DESCRIPTION
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
DESCRIPTION
Type from 8 to 63 case-sensitive ASCII characters. You can set up the most
secure wireless connection by configuring WPA in the wireless LAN screens.
You need to configure an authentication server to do this.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
P-660HW-Tx v3 Series User's Guide