ZyXEL Communications P-660HW-Tx v3 Series User Manual page 321

FTP Command Configuration Backup Example
This figure gives an example of using FTP commands from the DOS command
prompt to save your device's configuration onto your computer.
Figure 131 FTP Session Example
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Configuration Backup Using GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-
based FTP clients.
Table 109 General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote
Directory
Initial Local Directory
Backup Configuration Using TFTP
The ZyXEL Device supports the up/downloading of the firmware and the
configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although
TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To backup the
configuration file, follow the procedure shown next.
P-660HW-Tx v3 Series User's Guide
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied
to the server for anonymous access. Anonymous logins will work
only if your ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary
mode.
Specify the default remote directory (path).
Specify the default local directory (path).
Chapter 22 Tools
321