Changing Needle; To Remove And Attach The Presser Foot; To Remove And Attach The Foot Holder - Kenmore 385.19606 Owner's Manual

Changing Needle
[] Raise the needJe by pressing the up/down needJe
button and lower the presser foot.
Turn off the power switch.
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.
[] Insert the new needle into the needle clamp with the flat
side to the rear.
When inserting the needle into the clamp, push it up as
far as it will go. Tighten the clamp screw firmly by
turning it clockwise.
[] To check for a good needle, put the flat side of the
needle onto something flat (the needle plate, glass.
etc.). The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt needle.
Needle clamp screw
(_ Pin
Needle clamp
[]
[]
To Remove and Attach the Presser Foot
[] Press the red button on the back of the foot holder. The
presser foot will drop off.
[] Place the selected presser foot so the pin on the foot
lies just under the groove of the foot holder. Lower the
presser bar to lock the foot in place.
Each foot is marked with a letter for an identification.
Q Red button
(_ Groove
(_ Pin
@ Identification letter
[] ÷
J;" [ D_-- 7[/= _ ¢=,"
To Remove and Attach the Foot Holder
[] To Remove:
Remove the thumb screw by turning the screw counter-
clockwise with the screwdriver.
[] To Attach:
Match the hole in the foot holder with the threaded hole
in the presser bar.
Fit the thumb screw into the hole.
Tighten the screw by turning clockwise with a
screwdriver.
(_ Thumb screw
(_ Foot holder
(_) Presser bar
[]
26