Garmin GNC 300 Pilot's Manual page 80

APPENDIX B
ROUTES
SECTION
5
User Data Transfer
Deleting Waypoints/
On-Route Direct-To
Deleting a route waypoint.
Highlight the desired waypoint and press
Waypoint sequencing set to 'hold'.
70
To delete a waypoint from the active route:
The active route page also allows you to select your next destination waypoint
manually from the active route waypoint list and resume the remainder of the route
in sequence. This procedure, referred to as an 'on-route' direct-to, allows the pilot
to fly the active route in a different sequence without editing the active route itself.
To perform an on-route direct-to from the active route page:
D
.
The GNC 300 will now provide guidance to the selected waypoint and resume
navigating the remainder of the route in sequence once you arrive at the next destina-
tion waypoint. The waypoint sequencing field, located at the bottom left of the
direct-to confirmation page, indicates the current setting of the external GPS SEQ
switch. Whenever the switch displays a 'HOLD' status, the GNC 300 will hold on the
current 'active-to' waypoint as your navigation reference and prevents the GPS receiv-
er from sequencing to the next waypoint in the route. For more information on hold-
ing at a waypoint and the GPS SEQ switch, see Section 6.
C
1. Press twice, if necessary, to activate the cursor.
O
2. Use to highlight the waypoint you would like to delete from the active route.
\ E
3. Press , followed by . The next route waypoint (if available) will move up to take
the position of the deleted waypoint.
C O
1. Press twice and rotate to highlight the desired waypoint.
D E
2. Press , followed by to confirm the 'ok?' prompt on the waypoint
confirmation page.