Garmin GNC 300 Pilot's Manual page 59

The third page available from the GNC 300' s WPT key is the user waypoint list,
which can be used to quickly scan, review, rename or delete user waypoints.
To display the user waypoint list:
W O
1. Press and use to display the user waypoint list.
2. To scroll through the list, rotate
The total number of user waypoints is displayed at the top of the page, with user
waypoints listed two at a time in alphabetical order. The scrolling arrow prompt,
located at the top left of the page, will indicate which direction to scroll to view addi-
tional waypoints. The status of each waypoint, if applicable, will be displayed to the
right of the identifier. A status will appear when it is the active-to waypoint, part of an
active or stored route, or a proximity waypoint. To edit, rename or delete waypoints,
the cursor must highlight the desired waypoint.
To highlight a waypoint:
C
1. Press twice and use
To edit a highlighted waypoint:
E
1. Press to obtain the waypoint position page. Edit the waypoint as described on pages
45-46. Note: The active-to waypoint cannot be edited.
To delete a waypoint from the list:
1. Highlight the desired waypoint and press
To rename a waypoint from the list:
1. Highlight the desired waypoint. Use
identifier for the waypoint.
E
2. Press on the confirmation page to change the name, or press
K
.
O
to highlight the desired waypoint.
\ E
. Press to confirm the deletion.
K O
and to enter a new
\
to cancel.
REFERENCE
WPT KEY SECTION
Route Copying and
User Waypoint List
Closest Pt of
Approach (CPA)
User Waypoint List
Renaming a user waypoint.
3
49