Garmin GNC 300 Pilot's Manual page 37

The scheduler function will display reminder messages after a certain elapsed time such
as Change oil, Switch fuel tanks, Overhaul, etc. For example, if you enter 'Change Oil' to be
displayed in 30 hours, the message 'Change Oil' will be displayed after the GNC 300 has
been on in Normal operating mode for 30 hours. After appearing, the message will be dis-
played each time the GNC 300 is turned on until it is changed or deleted.
Entering a scheduled message.
To enter a scheduled message:
N O
1. Press and rotate
C
2. Press twice and rotate
K
3. Rotate to display the message you would like to edit. Press
highlight the message you would like to edit. To delete, press
K O
4. Use and to enter the message. Press
K O
5. Use and to set the elapsed time until the message is displayed, in hours and
minutes, up to 99 hours and 59 minutes (this time is cumulative and counts whenever
the GNC 300 is on in normal operating mode). Press
You may edit another by repeating steps 3, 4 and 5, or if you are finished, press C.
to display NAV Menu 2.
O
until 'Scheduler?' is highlighted. Press
C
\
, then
E
.
E
.
The scrolling arrow prompt indicates which direc-
E
.
tion to scroll to view additional listings.
O
and rotate to
E
.
The scheduled message will appear after the timer
expires and after the GNC 300 is powered up
until the message is changed.
REFERENCE
NAV KEY SECTION
1
WPT Key Overview
NAV Menu 2
Scheduler
27