Table of Contents
Advertisement
Keyset Mode
When telephone is set to AT command mode, these AT
commands are supported.
Mode
Inactive
No CTI information is sent/received by the telephone.
ATD
Modem Dialing Command -- The telephone will recognize the
ATD and accept digits after the command.
ATH or
Modem On-Hook/Off-Hook Command -- ATH or ATH0 will force
ATHX
the telephone to go to the on-hook state from its current state.
(X= 0 or 1)
ATH1 will force the telephone to go to the off-hook state from
it's current state.
CKTU
Command used with Wanderer (a cordless key telephone unit).
The baud rate is not used in this mode; no change is necessary.
PC Phone
CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI
Service Provider Interface -- Command used with TAPI
applications such as Discovery Link
At an idle station:
1. Dial the Keyset Mode code [648] on the dial pad,
-or-
Press preprogrammed KEYSET MODE button, the following
displays:
2. Press [ ] to scroll through the keyset modes.
3. Press [#] to scroll through the baud rates.
4. Press the HOLD button to save the desired entries.
Table 1: AT Command Modes
I NACTI VE
MODE=
SAVE=HOLD BAUD=#
Description
2400
63
Advertisement
Table of Contents
