Conference Procedures - STARPLUS Triad XTS User Manual

48

Conference Procedures

8-button digital/electronic telephones can assign a Conference
button by using feature code 624.
To establish a Conference:
1. Lift handset.
2. Select intercom station or dial desired outside party.
3. When called party answers, press the CONF button.
4. Add next conference party by selecting another outside
line or intercom station.
5. If the next conference party is an outside line and a busy or
wrong number is encountered, press one of the conference
parties on hold. This drops the busy or wrong number
party. Press the conference button again and repeat step 4.
6. When last party answers, press the CONF button twice. (All
parties are connected.)
To exit a Conference (controller only) perform ONE of the
following:
1 -- Press the ON/OFF button to ON, press MUTE, then
replace the handset (to monitor a conference).
To exit a multi-line conference in progress:
2 -- Press the HOLD button to place outside parties on
hold. The Hold Timer starts. If one of the two parties is
internal, that party is dropped.
3 -- Press CONF and hang up or press the ON/OFF
button to leave the other conference parties still
connected in an unsupervised conference. The CONF
button flashes and the timer starts. There is a warning
tone before the other parties are dropped.
To re-enter a Conference:
When the controller re-enters the conference, the disconnect
timer is reset.
Conference