NEC Express 5800 User Manual page 77

7. Click [OK].
The [Intel(R)PROSet II] dialog box closes after a while, and the settings become effective.
IMPORTANT:
The [Digital signature not found] dialog box may appear (several times). If it appears,
click [Yes].
After setting dual configuration, "Intel(R) Advanced Network Services Virtual
Adapter" will appear on the [Network and dialup connection] or the [Device
Manager] dialog box. Therefore 6 adapters that consist of two "Virtual", two
"100Base", and two "1000Base" adapters will appear on the [Network and dialup
connection] or the [Device Manager] dialog box. Do not disable the virtual adapters.
If you disable and enable them again, the system may become unstable and you may
need to restart it.
Set IP address for "Virtual Adapter" after setting dual configuration. Do not specify IP
address for "100Base Adapter" or "1000Base Adapter".
For dual configuration, use a hub. For AFT function, use a repeater hub or a switching
hub. For ALB function, use a switching hub.
Connect the network cables to the both primary and secondary PCI modules. After
setting of dual configuration, if one network cable is disconnected from a PCI module
or a hub, the status of the PCI modules becomes simplex. In such case, the status will
change to duplex if the network cable is connected to the PCI module or the hub
again.
Windows Setup 4-35