NEC Express 5800 User Manual page 53

(2) Make sure that the two BMC Status LEDs of the PCI modules (for Group1/for Group2) are
turned off.
IMPORTANT:
(3) and on. Otherwise the BMC firmware may become damaged.
(3) Remove the power cord of the AC inlet A (for Group2).
(4) Check that the POWER switch of the PCI module for Group1 is turned on.
(5) Connect the power cord of the AC inlet A (for Group2).
(6) Make sure that two BMC Status LED for PCI modules (for Group 1/for Group 2) are turned
off.
IMPORTANT:
setup after the LED is turned off. Otherwise the setup may not be done properly.
Preparation is now completed.
While the BMC Status LED is red and blinking, do not perform
If the BMC Status LED is red and blinking, start the ft series
Windows Setup 4-11