NEC Express 5800 User Manual page 61

The message "The system will be rebooted." appears on the screen
CHECK:
momentarily. The server will restart automatically and no user intervention is required.
Installing required software ...
Formatting drive...
FORMAT v7.10 (Revision4.11.1364)
Copyright(c) 1989-2002 Datalight, Inc.
Formatting 3.07G
XX percent complete.
After the hard disk drive is formatted, the message about copying the NEC Express5800/ft series
system software to the system drive from the CD-ROM.
Wait about 5 minutes until copying is completed.
Copyright(c) 1989-2002 Datalight, Inc
Formatting 3.07G
100 percent complete
Writing out file allocation table
Complete.
Calculating free space (this may take several minutes). . .
Complete.
Format complete.
System transferred
3,068.90 MB total disk space
114,688 bytes used by system
3,068.79 MB available on disk
4,096 bytes in each allocation unit.
785,606 allocation units available on disk.
Volume Serial Number is XXXX-XXXX
Copying necessary NEC Express5800/ft series system software to the
system drive... Approximately 5 minutes.
7. After finishing copying the software to the system drive, the following message will appear.
Remove the CD-ROM and press Enter. The NEC Express5800/ft series is restarted
automatically.
Necessary NEC Express5800/ft series software has been copied.
Remove the CD-ROM from the CD-ROM drive, and press [ENTER] to finish.
The system will reboot from the Hard Disk Drive.
IMPORTANT:
machine starts up with the CD-ROM inside, the system will be started up from the
Make sure to remove the CD-ROM from the CD-ROM drive. If the
Windows Setup 4-19