NEC Express 5800 User Manual page 145

7. After the system's update is completed, the dialog box
The system w ill be rebooted. Eject a CD from CD-ROM drive after the reboot process starts.
IMPORTANT:
When the language selection message for Microsoft HotFix to install appears,
follow the instructions on the window.
Install which version of the Microsoft HotFix?
1.English
2.Simplified Chinese
3.Traditional Chinese
4.Ger
5.S panish
6.French
7.Italian
8.Korean
Enter a number [1-8]?
(Note) If there is no Microsoft HotFix suitable for the current environment, HotFix
will not be applied.
If the message, "Window
volu me can no longer be accessed" is displayed d
stop error may occur when restarting the OS. If an O
f ollowing procedures. In this case, the system will be successfully updated, however,
disk mirroring is disabled. Make sure to check disk mirroring in 8.
1) Power off the system by pressing and holding the POWER switch.
2) Make su
Group2) are
While t
Otherw
3) Ide
Remem
green.
See the rea
- If PCI mo
unplug the power cord connected to "AC inlet B (for Group 1)" on the rear of
machine. (See page 4-9 for details.)
- If PCI module (for Group2)'s POWER switch is lit green,
man
s - FT Orphaning A disk that is part of a fault-tolerant
re that the two BMC Status LEDs of the PCI modules (for Group1/
turned off.
he BMC Status LED is red blinking, do not perfor
ise the BMC firmware may become damaged.
ntify the PCI module where POWER switch is lit green.
ber w hich PCI module's POWER
Unplug the power cord connected to the following AC inlet.
r view of this product in page 4-9 for the location of the AC inlet.
dule (for Group1)'
below will be displayed. Click [OK].
uring the update process, an OS
switch (for Group1 or Group2) is lit
s POWER switch is lit green,
Troubleshooting
S stop error occurs, perform the
m step 3) and the following.
6-19