Second Panel Of One-Touch Keys (Okifax 5950 Only); Signal Tones - Oki OKIFAX 5750 User Manual

5750GB.book Page 12 Tuesday, June 6, 2000 8:08 PM
English
dial number, then complete the process by following the procedures
required for entering another Speed Dial number (in which the second part
of the number should be entered).
PAUSE key (one-touch key #40): Use this key to enter automatic 3-
second pauses in dialling when programming telephone numbers. For
example, use this key to tell the machine to wait for an outside or interna-
tional line to open. Pauses in a telephone number dialling sequence are
indicated by a "P".
Other: Special character keys (, ; @ _ : / \ . +).

Second panel of one-touch keys (OKIFAX 5950 only)

To access the second panel of one-touch keys (41-80) grasp the latch at
the bottom of the keypad and lift up on the main panel, swinging it up and
to the rear. After pressing the desired key(s), close the panel.

Signal tones

The machine emits a number of sounds to inform the user of specific
conditions.
Key select tone - This is a short beep emitted each time a key is pressed.
Error tone - If an inappropriate key is pressed, the machine will emit
three short beeps. If there is a problem with operations during communi-
cation, the machine will emit five long beeps. Press the STOP key to turn
the error tone off and then print a Message Confirmation Report to check
the source of the problem. To do this, press the ENTER key twice in
succession with no documents loaded.
End of session tone - At the end of each successful faxing session, the
machine will emit a long beep to confirm that there were no errors or prob-
lems in the communication.
Off-hook alarm tone - If the machine is equipped with a telephone
handset and if the receiver of the handset is left out of the cradle when not
in use, the machine will emit an intermittent warbling sound. To turn off
the alarm, replace the handset in the cradle.
12