Settings; Isdn Dial Mode (User Setting); Isdn Dial Mode (Communication Parameter); Speech Receive (User Setting) - Oki OKIFAX 5750 User Manual

5750GB.book Page 109 Tuesday, June 6, 2000 8:08 PM
ISDN ID: This number is a terminal identifier. Up to ten alphabetic char-
acters (uppercase or lowercase) can be used. (Default setting.)
ISDN SUB: This is the sub-addressing number for directing communica-
tions. Up to 19 numbers can be used.
Please be sure to register the ISDN country code, ISDN number and ISDN
ID into the fax machine. If these items are not registered ISDN service
may be denied.

Settings

ISDN dial mode (user setting)

Set to G3: The call originates in G3 mode when dialled from the numeric
keypad. At the time, 3.1 kHz analogue transmission is requested to the
network.
Set to G4: The call originates in G4 mode when dialled from the numeric
keypad. Non-restricted digital transmission is requested to the network.
(default setting.)

ISDN dial mode (communication parameter)

Set to G3: The call originates in the G3 mode when dialled from Speed
Dial entry. At the time, 3.1 kHz analogue transmission is requested to the
network.
Set to G4: The call originates in G4 mode when dialled from Speed Dial
entry. Non-restricted digital transmission is requested to the network.
(default setting.)

Speech receive (user setting)

Set to OFF: Allows limited reception of analogue communications. The
limitations when set to OFF depend on the ISDN network that the fax
machine is connected to.
Set to ON: Enables the reception of analogue communications from the
network.
Note: For analogue transmission capabilities, please contact your
authorised supplier.
Appendix D - ISDN G4 Board
English
109