Fujitsu PRIMERGY BX600 S2 Operating Manual page 59

Preparation for Use and Operation
I
The management blade LAN controller only runs at 10 Mbit/sec.
Duplex mode must be defined manually via the Agent NTC Duplex
Mode (see
Figure 21: Agent NIC Duplex Mode menu
Ê Enter 2 if the preset duplex mode value needs to be altered or 0.
I
The transfer rate of 10 Mbit/sec and the duplex mode of the
management blade must comply with the client LAN controller!
Automatic synchronization is not supported by the management
blade LAN controller.
Ê Enter 0 in this menu and in the preceding menus to leave the management
blade console menu.
Ê Close the HyperTerminal session.
Ê Unplug the power cable from the basic unit and plug it in again to reboot the
management blade.
I
This ensures that the management blade continues to act as the
master after the restart. A restart without interruption to the power
supply would cause the master/slave assignment to change.
The management blade can now be accessed via the LAN. For more infor-
mation on the management blade configuration, see the manual
BX Blade Server Systems: RemoteView Management Blade - User Interface
Description". Information on the configuration of the various switch blade
models can be found in sparate manuals, see
page 165.
PRIMERGY BX600 S2 Basic Unit
figure 21 below).
Management Blade Configuration
"Related Publications" on
"PRIMERGY
59