Overview: Basic Unit Installation Steps - Fujitsu PRIMERGY BX600 S2 Operating Manual

2 Overview: Basic Unit Installation
Steps
In this chapter you will find an overview of the steps necessary to install your
BX600 S2 basic unit. Links guide you to sections where you can find more
detailed information on the individual steps.
Ê Before you begin, please read the
page 21, especially the
Ê Unpack the system, check the contents of the package for visible transport
damage, and check whether the delivery matches the details in the delivery
note (see section
Ê Mount the system in the rack (see section
arrangement on the order lists).
Ê Cable the system (see section
"Cable Routing" on page 43
Disconnecting Cables" on page
Ê Connect the system to the mains voltage (see section
Ê Familiarize yourself with the operating and indicator elements on the front
and rear sides of the BX600 S2 basic unit (see chapter
page 49).
Ê Insert the server blades into the slots in the front of the BX600 S2 basic unit
(see chapter 7 on page
Ê Configure the management blades (see section
can perform further administration of the blade server system via LAN.
Ê Install the desired operating systems and applications on the server blades.
To do so, you have the following options:
– Cloning a server blade from a remote image server with RemoteDeploy
Recommended if the following requirements are satisfied:
– the RemoteDeploy software is available
– an appropriate cloning image is available
– deployment server and LAN connection are available
PRIMERGY BX600 S2 Basic Unit
chapter "Important Notes"
section "Notes on
4.2 on page 34).
4.4 on page
and the
45.
71).
Safety".
4.3 on page 35
41). Please also see the
section "Instructions on Connecting and
5.3 on page
beginning on
and also the layout
section
4.5 on page 46).
5 beginning on
55) so that you
19