Fujitsu PRIMERGY BX600 S2 Operating Manual page 54

Switching the Blade Server ON/OFF
Other Ways to Switch ON the Basic Unit
– Using the web interface of the management blade
Using the web interface of the management blade, you can switch on the
basic unit as well as each of the server blades.
– After power failure
The basic unit automatically switches ON following a power failure, and the
server blades which were operating before the power failure are booted
automatically.
Switching the Server Blades ON/OFF
The basic unit must be powered ON.
The server blade can be switched ON and OFF in the following ways:
– To switch ON the server blade, press the power button of the server blade
(see the manual for the relevant server blade type).
To switch OFF the server blade, press the power button of the server blade
(see the manual for the relevant server blade type) for 4 seconds.
– Specified switch-ON time/switch-OFF time
The server blade is switched ON or OFF at a time specified in the ServerView
program.
– Ring indicator
The server blade is switched ON via an external modem.
– After power failure
The server blade automatically switches ON following a power failure
(depending on the settings in the BIOS).
54
Preparation for Use and Operation
PRIMERGY BX600 S2 Basic Unit