Table of Contents
Advertisement
CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier®
Front Panel Operation
When Demo Mode is turned On, the following messages display:
Please Wait... Resetting
Factory Defaults
PROCESSOR BOOTING...PLEASE WAIT!
[
When the allotted demo period expires, the following message displays:
FAST Demo Mode: Off
From this time forward, once Demo Mode expires, the display reverts to the previous
(Demo Mode) submenu and On is rendered non-selectable.
UTILITY: FAST
View Options: 02
1:2 Redun
Use the
▲ ▼
Installed for base unit operation. Press
UTILITY: FAST
FAST - Slot#1: Mod
FAST - Slot#2: Demod
Where # denotes the selected Slot#1, #2, #3 or #4: The Slot# menu screen indicates whether the
installed module is a Modulator, or Demodulator. If no module is present in the selected slot, the
following message displays:
INSTALLED IN THIS SLOT!
The user will then be taken to the menu screen for the last valid slot in the configuration. From
there, select Mod (Demod) or Turbo using the
UTILITY: FAST
FAST: Config
Board S/N: 223456789
FAST: Config
Board S/N: 323456789
As with the menu screen for
number for the board of the specific module installed in this slot position. Additionally, the
module type and its slot position are identified here. In the examples shown above, a Modulator
module resides in the Slot#1 position; a Demodulator module resides in Slot#2.
Select Config or View using the
Demo Period Expired
Base
- Installed
arrow keys to display which FAST options are either Installed or Not
Slot#
THERE IS NO CARD
Slot#
View
View
UTILITY: FAST Base
◄ ►
]
On
View
(▲ ▼,ENT)
when done.
ENTER
Turbo
(▲ ▼,ENT)
Turbo
(▲ ▼,ENT)
◄ ►
arrow keys, then press
Mod, Demod
(Mod#1)
(Dem#2)
, this menu screen identifies the serial
arrow keys, then press
5–63
MN/CDMQX.IOM
.
ENTER
.
ENTER
Revision 7
Advertisement
Table of Contents
