Dell PowerConnect W-Airwave User Manual page 92

Table 53 Groups > Security Page Fields and Default Values (Continued)
Setting
Permit RADIUS-Assigned
Dynamic VLANs
VLAN ID Format
Ethernet Untagged VLAN ID
(1-4094)
General Section
Create Closed Network
Block All Inter-client
Communication
EAP Options Section
WEP Key Rotation Interval
Session Key Refresh Rate
Session Timeout
Cisco TKIP
Cisco MIC
RADIUS Authentication Servers Section
RADIUS Authentication
Server #1 - #4
Authentication Profile
Name
Authentication Profile
Index
RADIUS Accounting Servers Section
RADIUS Accounting Server
#1 - #4
92 | Configuring and Using Device Groups in AWMS
Default Description
No This setting enables dynamic VLANs to be assigned by the RADIUS server. This
setting is supported only for HP ProCurve 420.
Hex This setting defines the naming convention for VLANs to be supported in AWMS.
The supported naming formats are ASCII and Hexadecimal.
1 This field defines the VLAN that will use untagged Ethernet. The VLAN must be a
number between 1 and 4094, and defines the untagged VLAN ID for the RoamAbout
AP3000.
No If enabled, the APs in the Group do not broadcast their SSIDs.
NOTE: Aruba recommends creating a closed network to make it more difficult for
intruders to detect your wireless network.
No If enabled, this setting blocks client devices associated with an AP from
communicating with other client devices on the wireless network.
NOTE: This option may also be identified as PSPF (Publicly Secure Packet
Forwarding), which can be useful for enhanced security on public wireless
networks.
300 Sets the frequency at which the Wired Equivalent Privacy (WEP) keys are rotated in
the device group being configured. The supported range is from 0 to 10,000,000
seconds.
0 Sets the frequency at which the general session key is refreshed in the device
group being configured. The supported range is from 1 to 40 minutes. This setting is
supported only for HP ProCurve 420.
0 Sets the time at which the session times out for the device group being configured.
The supported range is from 0 to 65,535 seconds. This setting is supported only for
HP ProCurve 420.
No Sets the device group to use the Cisco Temporal Key Integrity Protocol (TKIP). If
enabled, TKIP provides per-packet key mixing, a message integrity check and a re-
keying mechanism, thus fixing the flaws of WEP.
NOTE: TKIP can only be enabled when EAP-based security is used.
Disabled Sets the device group to use the Cisco Message Integrity Check (MIC). Selecting
MMH encryption enables this function.
If enabled, Message Integrity Check (MIC) adds several bytes per packet to make it
more difficult to tamper with the packets.
Not selected Defines one or more RADIUS Authentication servers to be supported in this device
group. Select up to four RADIUS authentication servers from the four drop-down
menus.
AMP- For Proxim devices only, this field sets the name of the authentication profile to be
Defined supported in this device group.
Server #1
1 For Proxim devices only, this field sets the name of the authentication profile index
to be supported in this device group.
Not selected Defines one or more RADIUS Accounting servers to be supported in this device
group. Select up to four RADIUS accounting servers from the four drop-down
menus.
Dell PowerConnect W AirWave 7.1 | User Guide