Dell PowerConnect W-Airwave User Manual page 89

Table 47 HP ProCurve 420 Fields and Default Values
Setting
SNMP Version
Note: DST Start Month, Start Day, End Month and End Day are only visible if Daylight Saving Time is enabled in the NTP section of
the Groups > Basic configuration page.
14. To configure Symbol or Intel-specific settings, locate the Symbol/Intel section and adjust these settings as
required.
Table 48 Symbol/Intel Fields and Default Values
Setting
SNMP Version
Symbol/Intel Client
Inactivity Timeout
(3-600 min)
Symbol Controller
CLI Communication
Web Config
Interface
15. To configure settings specific to Dell PowerConnect W, locate the Dell PowerConnect W section and adjust
these settings as required. Table 49 describes the settings and default values of this section.
Table 49 Dell PowerConnect W Fields and Default Values
Setting
SNMP Version
Offload Dell
PowerConnect W
WMS database
Dell PowerConnect
W GUI Config
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
AP.
Table 48 describes the settings and default values of this section.
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the
device.
3 Sets the minutes of inactivity after which a client associated to an Intel or Symbol AP will
be considered "inactive." A lower value typically provides a more accurate representation
of current WLAN usage.
NOTE: For other APs, AWMS has more precise methods to determine when inactive clients
are no longer associated to an AP.
Telnet Select which connection type is to support the command-line interface (CLI) connection.
The options are Telnet and secure shell (SSH). This is supported for WS5100 and RFS7000
devices only.
Yes Enables or disables the http/https configuration page for the Symbol 4131 and Intel 2011
devices.
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the AP.
No Configures commands previously documented in the Dell PowerConnect W AirWave Best
Practices Guide. See the current Best Practices guide for more information about this
feature. When enabled, this feature allows AWMS to display historical information for WLAN
switches.
Changing the setting to Yes pushes commands via SSH to all WLAN switches in Monitor Only
mode without rebooting the controller. The command can be pushed to controllers in manage
mode (also without rebooting the controller) if the Allow WMS Offload setting on the AWMS
configuration page is changed to Yes.
Yes Enables or disables AWMS support for the Dell PowerConnect W configuration interface.
This setting relates to the Device Setup > Dell PowerConnect W Configuration page and all
related operations. For additional information, refer to the Dell PowerConnect W
Configuration Guide.
Configuring and Using Device Groups in AWMS | 89