Dell PowerConnect W-Airwave User Manual page 180

Table 94 Groups > Templates > Add Template Fields and Default Values
Setting Default
Use Global No
Template
Fetch None
Name None
AP Type Cisco IOS (Any
Model)
Reboot APs After No
Configuration
Changes
Restrict to this No
version
Template firmware None
version
Community String None
Telnet/SSH None
Username
Telnet/SSH None
Password
"enable" Password None
SNMPv3 Username None
Auth Password None
Privacy Password None
SNMPv3 Auth MD5
Protocol
SNMPv3 Privacy DES
Protocol
180 | Creating and Using Templates
Description
Uses a global template that has been previously configured on the
page. Available templates will appear in the drop-down menu. If Yes is selected you can also configure
global template variables. For Symbol devices you can select the groups of thin APs to which the template
should be applied. For more information about global templates see the Groups > Templates section of the
User Guide.
Selects an AP from which to fetch a configuration. The configuration will be turned into a template with
basic AP specific settings like channel and power turned into variables. The variables are filled with the
data on the APs/Devices > Manage configuration page for each AP.
Defines the template display name.
Determines that the template applies to APs or devices of the specified type. If Cisco IOS (Any Model) is
selected, the template applies to all IOS APs that do not have a version specific template specified.
Determines reboot when AWMS applies the template, copied from the new configuration file to the
startup configuration file on the AP. If No is selected, AWMS uses the AP to merge the startup and running
configurations. If Yes is selected, the configuration is copied to the startup configuration file and the AP is
rebooted.
NOTE: This field is only visible for some devices.
Restricts the template to APs of the specified firmware version. If Yes is selected, the template only
applies to APs on the version of firmware specified in the Template Firmware Version field.
Designates that the template only applies to APs running the version of firmware specified.
If the template is updating the community strings on the AP, enter the new community string AWMS should
use here. AWMS updates the credentials it is using to communicate to the device after the device has
been managed.
If the template is updating the Telnet/SSH Username on the AP, enter the new username AWMS should
use here. AWMS updates the credentials it is using to communicate to the device after the device has
been managed.
If the template is updating the Telnet/SSH password on the AP, enter the new Telnet/SSH password
AWMS should use here. AWMS updates the credentials it is using to communicate to the device after the
device has been managed.
If the template is updating the enable password on the AP, enter the new enable password AWMS should
use here. AWMS updates the credentials it is using to communicate to the device after the device has
been managed.
If the template is updating the SNMP v3 Username password on the AP, enter the new SNMP Username
password here. AWMS updates the credentials it is using to communicate to the device after the device
has been managed.
If the template is updating the SNMP v3 Auth password on the AP, enter the new SNMP Username
password here. AWMS updates the credentials it is using to communicate to the device after the device
has been managed.
If the template is updating the SNMP v3 Privacy password on the AP, enter the new SNMP Username
password here. AWMS updates the credentials it is using to communicate to the device after the device
has been managed.
Specifies the SNMPv3 Auth protocol, either MD5 or SHA-1.
Specifies the SNMPv3 Privacy protocol, either DES or AES.
Groups > Templates
Dell PowerConnect W AirWave 7.1 | User Guide
configuration