Dell PowerConnect W-Airwave User Manual page 114

Table 72 PTMP/WiMAX Configuring Packet Identification Rules Fields and Default Values
Setting
Mask
(positive integer)
Use Ethernet Type
Ethernet Type
Ethernet Value (positive
integer)
Ethernet Priority
Ethernet Priority Minimum
(0-7)
Ethernet Priority Maximum
(0-7)
Use VLAN ID
VLAN ID (positive integer)
Use Source IP Address
Source IP address
Use Destination IP Address No
Destination IP Address
Use IP Protocol
IP Protocol (0-255)
Use Source MAC Address
Source MAC Address
Use Destination MAC
Address
Destination MAC Address
5. To configure service flow classes, click the Configure service flow classes link on the Groups > PTMP/Wimax
configuration page, and define the settings. Service flow classes are used to describe how the device handles
traffic.
Figure 63 PTMP/WiMAX Configuring Service Flow Classes Page Illustration
114 | Configuring and Using Device Groups in AWMS
Default
0
No
DIX SNAP
0
No
None
0
No
0
No
None
None
No
None
No
None
No
None
Figure 63 illustrates this page and
Description
Specifies the TOS mask used to identify packets.
Identifies packets based on Ethernet type settings.
Drop-down menu specifies the Ethernet types used to identify a packet.
Identifies packets that have a specific ethernet value.
Identifies packets based on Ethernet Priority settings.
Identifies packets that meet a minimum priority.
Identifies packets that meet a maximum priority.
Identifies packets based on the VLAN ID.
Specifies the VLAN that will be used to identify packets.
Identifies packets based on source IP address.
Defines the source IP addresses that will be used to identify packets.
Identifies packets based on destination IP address.
Defines the destination IP addresses that will be used to determine identify
packets.
Identifies packets based on IP protocol.
Identifies packets that have a specific IP Protocol value.
Identifies packets based on Source MAC address.
Defines that packets from this MAC address match this PIR.
Identifies packets based on Destination MAC address
Defines that packets to this destination MAC address match this PIR.
Table 73 describes settings and default values.
Dell PowerConnect W AirWave 7.1 | User Guide