Dell PowerConnect W-Airwave User Manual page 86

Table 39 SNMP Polling Period Fields and Default Values (Continued)
Setting
CDP Neighbor Data Polling
Period
5. Record additional information and comments about the group in the Notes section.
6. To configure which options and tabs are visible for the group, complete the settings in the Group Display
Options section.
Table 40 Group Display Options Fields and Default Values
Setting
Show device
settings for:
Selected Device
Types
7. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the
Automatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this
section, additional fields appear. Complete these fields as required.
default values.
Table 41 Automatic Static IP Assignment Fields and Default Values
Setting
Assign Static IP
Addresses to
Devices
Start IP Address
Number of
Addresses
Subnet Mask
Subnet Gateway
Next IP Address
86 | Configuring and Using Device Groups in AWMS
Default Description
30 minutes Sets the frequency in which this group polls the network for Cisco Discovery
Protocol (CDP) neighbors.
Table 40 describes the settings and default values.
Default Description
Only Devices on Drop-down menu determines which Group tabs and options are to be viewable by
this AMP default in new groups.
Settings include the following:
All Devices—AWMS displays all Group tabs and setting options.

Only Devices in this group—AWMS hides all options and tabs that do not apply to

the devices in the group. If you use this setting, then to get the group list to display
the correct SSIDs for the group, you must perform a Save and Apply action on the
group.
Only Devices on this AMP—AWMS hides all options and tabs that do not apply to

the APs and devices currently on AWMS.
Use system defaults—Use the default settings defined on the AWMS configuration

page
Selected device types—Allows the user to specify the device types for which

AWMS displays Group settings.
Disabled If you chose to display selected device types, then this option appears, allowing you to
select the device types for which AWMS displays group settings. Click Select devices in
this group for a quick way to display only devices in the current group being configured.
Default Description
No Enables AWMS to statically assign IP addresses from a specified range to all devices in
the Group.
Blank Sets the first address AWMS assigns to the devices in the Group.
Blank Sets the number of addresses in the pool from which AWMS can assign IP addresses.
Blank Sets the subnet mask to be assigned to the devices in the Group.
Blank Sets the gateway to be assigned to the devices in the Group.
Blank Defines the next IP address queued for assignment. This field is disabled for the initial
Access Points group.
Table 41 describes the settings and
Dell PowerConnect W AirWave 7.1 | User Guide