Dell PowerConnect W-Airwave User Manual page 115

Table 73 Groups > PTMP/WiMAX Configure Service Flow Classes Fields and Default Values
Setting
Name
Scheduling Type
Service Flow
Direction
Maximum
Sustained Data
Rate (in Kbps)
Traffic Priority (0-
7)
6. To configure subscriber station classes, click the Configure subscriber station classes link on the Groups >
PTMP/Wimax configuration page. Subscriber station classes link packet identification rules and service flow
classes.
Figure 64 Groups > PTMP/WiMAX Configuring Subscriber Station Classes Page Illustration
Table 74 Groups > PTMP/WiMAX Configuring Subscriber Station Classes Fields and Default Values
Setting
Name
VLAN Mode
Service Flows
Packet Identification Rules
7. Click Save and Apply when configurations are complete and to push this configuration to controllers, or click
Save to retain these settings prior to pushing to controllers at a later time.
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
None Text field defines the name of the Service Flow Class. The name should be meaningful
and descriptive. The name is used to define the subscriber station class.
Best Effort Drop-down menu specifies the scheduling priority for the Service Flow Class. There are
two options as follows:


Uplink Defines the direction of the service.
0 Sets the maximum sustained data rate for this service class. The base station does not
allow the data rate to exceed this value.
7 Sets the priority of the traffic from 0 - 7 with 7 getting the highest priority.
Figure 64 illustrates this page and
Default
None
Transparent
None
None
Best Effort—Maximum sustained data rate and traffic priority
Unsolicited Grant Service—Maximum sustained data rate, maximum latency and
tolerable jitter.
Table 74 describes the settings and default values.
Description
Text field that defines the name of the Subscriber Station Class. The name
should be meaningful and descriptive.
Defines the VLAN mode.
Checkbox field that defines the service flow classes that apply to this
Subscriber Station Class.
Define the priority for all of the packet identification rules.
Configuring and Using Device Groups in AWMS | 115