Dell PowerConnect W-Airwave User Manual page 144

2. Verify that the devices you added are now appearing in the devices list with a Status of Up.
Note: Immediately after you have added the device to a group, notice the device
the device and fetches the configuration from the device to compare it to the group settings. The device
when verification is complete.
The same section also appears on the Groups > Monitor page, and is hyperlinked from a controller's
monitoring interface.
3. Navigate to the Alert Summary section of the APs/Devices > List page. The Alert Summary section cites the
number of events that have occurred in the last two hours, the last 24 hours, and total. There are four
categories of alerts as follows:
AMP Alerts

IDS Events

Incidents

RADIUS Authentication Issues

Note: The Alerts Summary table is also a feature of the Home > Overview page, and has the same links in that location.
Figure 90 APs/Devices > List > Alert Summary Section Illustration
4. You can view details and incidents by clicking the specific Alert Type. The alert types and detailed
information available for each are as follows:
 AMP
information for the current AMP Alerts.
144 | Discovering, Adding, and Managing Devices
Alerts—Clicking this link takes you to the AMP Alerts Summary page, which cites detailed
Status
Figure 91 illustrates this page.
Dell PowerConnect W AirWave 7.1 | User Guide
Down
change to while AWMS brings up
Status
will change to
Up