Dell PowerConnect W-Airwave User Manual page 44

Table 12 AMP Setup > General > Historical Data Retention Fields and Default Values (Continued)
Setting
Rogue AP Discovery
Events
(2-550 days)
Reports
(2-550 days)
Automatically
Acknowledged Alerts
(0-550 days, zero
disables)
Acknowledged Alerts
(2-550 days)
Traps from managed
devices
(0-550 days, zero
disables)
Archived Device
Configurations
(1-100)
Guest Users
(0-550 days, zero
disables)
Closed Helpdesk
Incidents
(0-550 days, zero
disables)
Inactive SSIDs
(0-550 days, zero
disables)
Inactive Interfaces (0-
550 days, zero disables)
Interface Status History
(0-550 days, zero
disables)
7. On the AMP Setup > General page, locate the Default Firmware Upgrade Options section and adjust
settings as required. This section allows you to configure the default firmware upgrade behavior for AWMS.
Table 13
Table 13 AMP Setup > General > Default Firmware Upgrade Options Fields and Default Values
Setting
Allow Firmware
upgrades in Monitor
Only mode
Simultaneous Jobs (1-
20)
44 | Configuring AWMS
Default Description
14 Defines the number of days AWMS stores Rogue Discovery Events. The longer you
store discovery event records, the more hard disk space you require.
60 Defines the number of days AWMS stores Reports. Large numbers of reports, over
1000, can cause the Reports > List page to be slow to respond.
14 Defines automatically acknowledged alerts as the number of days AWMS retains
alerts that have been automatically acknowledged. Setting this value to 0 disables this
function, and alerts will never expire or be deleted from the AWMS database.
60 Defines the number of days AWMS retains information about acknowledged alerts.
Large numbers of Alerts, over 2000, can cause the System > Alerts page to be slow to
respond.
14 Defines the number of days AWMS retains information about SNMP traps from
Managed Devices. Setting this value to 0 disables this function, and the trap
information will never expire or be deleted from the AWMS database.
10 Sets the number of archived configurations to retain for each device.
30 Sets the number of days that AWMS is to support any guest user. Setting this value to
0 disables this function, and guest users will never expire or be deleted from the
AWMS database.
30 Sets the number of days that AWMS is to retain records of closed Helpdesk incidents
once closed. Setting this value to 0 disables this function, and Helpdesk information
will never expire or be deleted from the AWMS database.
425 Sets the number of days AWMS retains historical information after AWMS last saw a
client on a specific SSID. Setting this value to 0 disables this function, and inactive
SSIDs will never expire or be deleted from the AWMS database.
425 Sets the number of days AWMS retains inactive interface information after the
interface has been removed or deleted from the device. Setting this value to 0
disables this function, and inactive interface information will never expire or be
deleted from the AWMS database.
425 Sets the number of days AWMS retains historical information on interface status.
Setting this value to 0 disables this function.
describes the settings and default values of this section.
Default Description
No If yes is selected, AWMS upgrades the firmware for APs in Monitor Only mode. When
AWMS upgrades the firmware in this mode, the desired configuration are not be pushed
to AWMS. Only the firmware is applied. The firmware upgrade may result in
configuration changes. AWMS does not correct those changes when the AP is in
Monitor Only mode.
20 Defines the number of jobs AWMS runs at the same time. A job can include multiple APs.
Dell PowerConnect W AirWave 7.1 | User Guide