Dell PowerConnect W-Airwave User Manual page 117

Table 77 Groups > Mesh Radio Settings > Mesh Count Matrix Fields and Default Values
Setting
Hop Factor
Maximum Hops
to Portal
RSSI Factor
Minimum RSSI
Cutoff
Medium
Occupancy
Factor
Current Medium
Occupancy
Weight
4. Click Save when configurations are complete to retain these settings. Click Save and Apply to retain these
settings and push them to devices in the group. Click Revert to cancel out of these changes and return to the
most recently saved changes.
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
5 Sets the factor associated with each hop when calculating the best path to the portal AP.
Higher factors will have more impact when deciding the best uplink.
4 Set the maximum number of hops for the AP to reach the Portal AP.
5 Sets the factor associated with the RSSI values used when calculating the best path to the
portal AP. Higher factors will have more impact when deciding the best uplink.
10 Specifies the minimum RSSI needed to become a mesh neighbor.
5 Sets the factor associated with Medium Occupancy when calculating the best path to the
portal AP. Higher factors will have more impact when deciding the best uplink.
7 Specifies the importance given to the most recently observed Medium Occupancy against all
of the previously viewed medium occupancies. Lower values place more importance on
previously observed Medium Occupancies.
Configuring and Using Device Groups in AWMS | 117