Dell PowerConnect W-Airwave User Manual page 150

Table 82 APs/Devices > Monitor > General Fields and Default Values (Continued)
Field
Configuration
Firmware
Controller
a
Portal
Mesh Mode
Hop Count
Type
Last Polled
Uptime
LAN MAC Address
Serial
Radio Serial
Antenna Type
Radio Transmit
Power
Location
Contact
IP
SSID
Total Users
First Radio
Second Radio
Channel
Users
Bridge Links
Mesh Links
150 | Discovering, Adding, and Managing Devices
Description
Good means all the settings on the AP agree with the settings AWMS wants them to have. Mismatched
means there is a configuration mismatch between what is on the AP and what AWMS wants to push to the
AP. The Mismatched link directs you to this specific APs/Devices > Audit page where each mismatch is
highlighted.
Displays the firmware version running on the AP.
Displays the controller for the associated AP device. Click the controller name hyperlink to display the
APs/Devices > Monitor page, which contains detailed controller information. Controller information
includes Status, operational metrics, Controller Client Count by SSID, Controller Bandwidth by SSID, CPU
Utilization, Memory Utilization, APs Managed by this Controller, Alerts, and Recent Events.
illustrates the Controller page.
Specifies the mesh AP acting as the wired connection to the network for this mesh AP.
b
Specifies whether the AP is a portal device or a mesh AP. The portal device is connected to the network
over a wired connection. A mesh AP is a device downstream of the portal that uses wireless connections
to reach the portal device.
c
Displays the number of mesh links between this AP and the portal.
Displays the make and model of the access point.
Displays the most recent time AWMS has polled the AP for information. The polling interval can be set on
the Groups > Basic page.
Displays the amount of time since the AP has been rebooted. This is the amount of time the AP reports and
is not based on any connectivity with AWMS.
Displays the MAC address of the Ethernet interface on the device.
Displays the serial number of the device.
Displays the serial number of the radios in the device.
NOTE: This field is not available for all APs.
Indicates internal or external radio. For devices where antenna type is defined per AP, including Aruba
devices, the same antenna type will be listed for each radio.
Some devices report transmit power reduction rather than transmit power; no value is reported for those
devices.
Displays the SNMP location of the device.
Displays the SNMP contact of the device.
Displays the IP address that AWMS uses to communicate to the device. This number is also a link to the AP
web interface. When the link is moused over a pop-up menu will appear allowing you to http, https, telnet
or SSH to the device.
Displays the SSID of the primary radio.
Displays the total number of users associated to the AP regardless of which radio they are associated to,
at the time of the last polling.
Displays the Radio type of the first radio (802.11a, 802.11b or 802.11g).
Displays the Radio type of the second radio (802.11a, 802.11b or 802.11g.
Displays the channel of the corresponding radio.
Displays the number of users associated to the corresponding radio at the time of the last polling.
Displays the number of bridge links for devices that are point-to-multi-point (see the Groups > PTMP/
WiMAX page for more details).
d
Displays the total number of mesh links to the device including uplinks and downlinks.
Dell PowerConnect W AirWave 7.1 | User Guide
Figure 98