Dell PowerConnect W-Airwave User Manual page 138

Table 80 Device Communications and Location Fields and Default Values
Setting
Privacy
Password
(Confirm)
SNMPv3 Auth
Protocol
SNMPv3 Privacy
Protocol
Telnet/SSH
Username &
Password
(Confirm)
Enable Password
(Confirm)
HTTP Username
& Password
Auth Password
Privacy
Password
4. In the Location field, select the appropriate group and folder for the device. Refer to
Table 81 Device Setup > Communications > Add > Location Section Fields and Default Values
Setting
Group
Folder
5. At the bottom of the page, select either the Monitor Only or Management read/write radio button. The
choice depends on whether or not you wish to overwrite the Group settings for the device being added. For
more information and a detailed procedure, see
Page" on
Note: If you select Manage read/write, AWMS overwrites existing device settings with the
placing newly discovered devices in Monitor read/only mode to enable auditing of actual settings instead of Group Policy settings.
6. Click Add to finish adding the devices to the network.
138 | Discovering, Adding, and Managing Devices
Default
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Taken from the Device Setup >
Communication page
Default AP Type
Default Group All
Top All
page 134.
Description
SNMPv3 privacy password.
Drop-down menu that allows you to enable the SNMPv3 authentication
protocol to the device being added.
Drop-down menu that allows you to enable SNMPv3 privacy protocol to
the device being added.
Telnet username and password for existing Cisco IOS APs. AWMS uses
the Telnet username/password combination to manage the AP and to
enable SNMP if desired.
NOTE: New, out-of-the-box Cisco IOS-based APs typically have SNMP
disabled with a default telnet username of Cisco and default password of
Cisco. This value is required for management of any existing Cisco IOS-
based APs.
Password that allows AWMS to enter enable mode on the AP.
HTTP password used to manage the AP initially, and to enable SNMP if
desired.
NOTE: Enter Intel if you are supporting new, out-of-the-box Intel APs.
SNMPv3 authentication password.
NOTE: SNMPv3 supports three security levels: (1) no authentication and
no encryption, (2) authentication and no encryption, and (3) authentication
and encryption. AWMS currently only supports authentication and
encryption.
SNMPv3 privacy password.
NOTE: SNMPv3 supports three security levels: (1) no authentication and
no encryption, (2) authentication and no encryption, and (3) authentication
and encryption. AWMS currently only supports authentication and
encryption.
Description
This is a drop-down menu used to assign the AP to a Group.
This is drop-down menu used to assign the AP to a Folder.
"Assigning Devices to AWMS from APs/Devices > New
Dell PowerConnect W AirWave 7.1 | User Guide
Table 81.
Group settings. Aruba recommends