Check Drum Menu - Xerox C2424 - WorkCentre Color Solid Ink Service Manual

Tray 2, Tray 3, Tray 4, Lift Plate Drive (Continued)
This test raises the lift plate to verify motion and sensor operation. If the test is requested for a
525-sheet feeder that is not installed, an "Option Not Detected" message is generated.
R# Definition
4 Lift Contact Time
(sec)
5 Lift Time (sec)
6 Stall Power (watts)

Check Drum Menu

Y-axis Encoder
Uses the sine and cosine sum data to determine the characteristics of the encoder disk and
encoder sensors.
R# Definition
0 Sin Sum Data
Amplitude (sin sum
units)
1 Cosine Sum Data
Amplitude (cosine
sum units)
2 Sin Sum Data Offset
(sin sum units)
3 Cosine Sum Data
Offset (cosine sum
units)
4 Home Notch Depth
Ratio (none)
5 Home Notch Width
(sec)
6 Home Notch
Symmetry (none)
4-40
Typical
Value Actions
MFG Reports the interval from the motor start time
Only until the required lift power starts to increase
due to the initial contact with the nudger roller
assembly.
MFG Reports the interval from the motor start time
Only until plate lifted is indicated.
MFG Reports the average stall power during the
Only overlifting interval.
Typical
Value Actions
MFG Reports difference between the max and min
Only Sin Sum average amplitude values.
MFG Reports difference between the max and min
Only Cosine Sum average amplitude values.
MFG Reports average of the max and min Sin Sum
Only average amplitude values.
MFG Reports average of the max and min Cosine
Only Sum average amplitude values.
MFG Reports the ratio between the notch bottom
Only amplitude and the max amplitude value as
reflected in the Sin Sum data.
MFG Reports the width of the Home notch at 99%
Only full depth as reflected in the Sin Sum data.
MFG Reports the ratio of the Home notch width
Only sections as bisected by a vertical from the
notch min as reflected in the Sin Sum data.
WorkCentre C2424 Service Manual