Xerox C2424 - WorkCentre Color Solid Ink Service Manual page 167

Service Diagnostics Main Menu Definition Table (Continued)
Menu Item
Test Name
Exercise Lamp
Exercise Axis
Motion
Reset Scanner
Main Menu --> Doc Handler Menu
Test Name
Report FW Version
Report Status
Report Paper
Status
Perform Selftest
Test DRAM
General Troubleshooting
Description
This tests commands the
scanner to cycle the lamp
on, then off.
The lamp is then left ON.
The scanner axis moves to
the maximum of its travel
position, then back to the
home (left) position.
This test power cycles the
IIT unit (MEP, Scanner,
DADF).
Description
Reports the current firmware version.
Checks then reports the
current status as reported by
the DADF unit firmware.
Reports the presence of
paper in the DADF unit.
This tests performs the built-
in self test procedure for the
DADF.
Tests the DRAM.
Description
Results
The lamp status must be
observed.
OK
Fail
OK or Fail.
Ready or Not Ready
Results
Ready or Not Ready
Lamp:
ON, OFF, Warming Up,
Warmup test not done,
Test fail
Error:
OK, Paper Jam, Cover
Open, Internal failure, Test
fail, Data Capture test fail,
Cal Device test fail.
Paper or no paper.
OK or Fail.
(This test may take several
minutes to complete.)
OK or Fail.
(This test may take several
minutes to complete.)
4-9