5,0Xx.4X Errors - Y-Axis Sub-System Fault - Xerox C2424 - WorkCentre Color Solid Ink Service Manual

5,0XX.4x Errors - Y-Axis Sub-System Fault

5,001.41: The drum turned one full revolution without seeing the drum home sensor
activate.
5,002.42:
The Y-Axis encoder is not working properly or the drum has stalled.
5,003.43:
There is a general problem with the Y-Axis sub-system.
Troubleshooting Procedure
Step Questions and Actions
1 1. From the service diagnostic Monitor Menu,
run the Y-axis Encoder test.
2. Did the test pass?
2 1. Inspect the Y-axis motor connector.
2. Is the wiring faulty?
3 1. Inspect the encoder wiring harness.
2. Is the wiring faulty?
4 1. Run the Y-axis Drive test.
2. Check the current values.
3. Are the values within normal operating
range?
5 1. Run the Y-axis Belt Tension test.
2. Check the current values.
3. Are the values within the normal operating
range?
6 1. Run the Y-axis Motor test.
2. Did the tests pass?
5,0XX.6x Errors - Program Faults
5,001.63:
There is a problem with the Y-Axis sub-sytem.
5,005.67:
If not in the homless or idle state, the system faults out. Software fault.
5,006.68:
Software fault.
5,008.61:
PostScript failed to fill the race buffer during imaging. Software fault.
5,009.62:
There were errors during imaging. Possible jets on/off outside of the
deadband area. Software fault.
a.
Reset NVRAM and retest.
b.
Ensure ground integrity for the system (see "Ensuring Ground Integrity" on
page 4-73).
c.
Replace the EEPROM chip.
d.
Reboot the system.
3-14
5,007.60:
Software fault.
Yes
Go to Step 2.
Replace the
wiring harness
or Y-axis motor.
Replace the
defective wiring.
Go to Step 5.
Go to Step 6.
Replace the
drum assembly.
WorkCentre C2424 Service Manual
No
Go to Step 3.
Go to Step 4.
Replace the
drum assembly.
Replace the
Y-axis motor.
Replace the
Y-axis belt.
Replace the
Y-axis motor.