Xerox C2424 - WorkCentre Color Solid Ink Service Manual page 155

Jam Code Troubleshooting Procedures
W4S Tray 3 motor stall during pick from Tray 3.
1. Ensure ground integrity of the system (see page 4-73).
2. Ensure the paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the 525-Sheet Feeder.
X2A Tray 3 pick flag triggered unexpectedly during abnormal shutdown.
X2B Tray 3 pick flag triggered unexpectedly on power-up following normal shutdown.
X2C Tray 3 pick flag triggered unexpectedly during mechanical recovery.
X2D Tray 3 pick flag triggered unexpectedly during warm-up.
X2E Tray 3 pick flag triggered unexpectedly during system ready.
X2F Tray 3 pick flag triggered unexpectedly while system was in a fault state.
X2L Tray 3 pick flag triggered unexpectedly while system in standby.
X2M Tray 3 pick flag triggered unexpectedly while picking from Tray 2.
X2N Tray 3 pick flag triggered unexpectedly while picking from Tray 3.
X2P Tray 3 pick flag triggered unexpectedly while picking from Tray 4.
X2Q Tray 3 pick flag triggered unexpectedly while picking from Tray 1.
X2R Tray 3 pick flag triggered unexpectedly while duplexing.
X2S Tray 3 pick flag triggered unexpectedly while transfixing.
X2V Tray 3 pick flag triggered unexpectedly while print drum maintenance cycle was
being performed.
X2W Tray 3 pick flag triggered unexpectedly during system imaging.
X2x (continued)
X2X Tray 3 pick flag triggered unexpectedly while exiting print.
1. Ensure ground integrity of the system (see page 4-73).
2. Ensure the paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the 525-Sheet Feeder.
5. Replace the pivot arm.
X3D Tray 3 pick flag sensor timed out during warm-up.
X3E Tray 3 pick flag sensor timed out during wile system ready.
X3F Tray 3 pick flag sensor timed out while system in fault state.
X3L Tray 3 pick flag sensor timed out while system in standby.
Error Messages and Codes
(Continued)
3-63