Xerox C2424 - WorkCentre Color Solid Ink Service Manual page 135

37,027.45:
PEST - X-axis motor disconnect. The X-axis motor is not drawing the
expected power from the supply (both phases).
37,028.46:
PEST - X-axis motor disconnect. The X-axis motor (first phase) is not
drawing the expected power from the supply.
37,029.47:
PEST - X-axis motor short. The X-axis motor is drawing too much power
from the supply (first phase).
37,030.48:
PEST - X-axis motor disconnect. The X-axis motor (second phase) is not
drawing the expected power from the supply.
37,031.40:
PEST - X-axis motor short. The X-axis motor is drawing too much power
from the supply (second phase).
Troubleshooting Procedure
Step Questions and Actions
1 1. Run the X-axis Drive test.
2. Did the test pass?
2 1. Check the X- axis motor wiring for damage.
37,032.41:
PEST - Y-axis motor disconnect. The Y-axis motor is not drawing the
expected power from the supply.
37,033.42:
PEST - Y-axis motor short. The Y-axis motor is drawing too much power
from the supply.
Troubleshooting Procedure
Step Questions and Actions
1 1. Remove any obstructions interfering with
drum rotation.
2. Inspect the drum and ensure the drum
rotates smoothly, if not replace the drum and
retest.
3. Did this correct the problem?
2 1. Disconnect the Y-axis belt.
2. Does the Y-motor shaft rotate smoothly?
3 1. Reconnect the Y-axis belt.
2. Run the Y-axis Motor test.
3. Did the test pass?
4 1. Check the wiring for damage.
Error Messages and Codes
Yes
Replace the Go to Step 2.
electronics
module.
Replace the X-axis motor.
Yes
Complete. Go to Step 2.
Go to Step 3. Replace the
Y-axis motor.
Replace the Go to Step 4.
electronics
module.
Replace the Y-axis motor.
No
No
3-43