Check Misc Menu - Xerox C2424 - WorkCentre Color Solid Ink Service Manual

Tray 3 and Tray 4 Pick/Feed Motor
This test turns on the specified motor and runs it at constant velocity for approximately 25
revolutions while recording drive data. The test is the same for each motor. Requesting a test for
a 525-sheet feeder that is not installed will generate an "Option Not Detected" message.
R# Definition
0 Motor fe ripple
(ticks)
1 Motor fe average
(ticks)
2 Motor drive voltage
ripple (volts)
3 Motor drive voltage
(volts)
4 Motor drive power
ripple (watts)
5 Motor drive power
average (watts)

Check Misc Menu

Paper Path Status
This test enters the paper path sensors to identify if anything would prevent a page from printing.
The control panel will display messages indicating if anything unexpected is found for: R0 = upper
paper path; R1 = tray 1; R2 = tray 2; R3 = tray 3; and R4 = tray 4. The display is a string of 0's and
1's (one digit for each sensor state) and is listed below from most significant bit to least significant
bit.
1 = an item that needs to be corrected.
0 = normal
R# Definition
0 Upper Paper Path
0
0
4-48
Typical
Value Actions
MFG Reports amount of variation of the motor
Only following error over the recording interval.
MFG Reports the motor following error average
Only value of the recording interval.
MFG Reports amount of variation of the motor drive
Only voltage over the recording interval.
MFG Reports the motor drive voltage average value
Only of the recording interval.
MFG Reports amount of variation of the motor drive
Only power over the recording interval.
MFG Reports motor drive power average value over
Only the recording interval.
Typical
Value Actions
MFG 6 -31 Not used, always 0
Only
MFG 5 - Front door open
Only
MFG 4 - Top door open
Only
WorkCentre C2424 Service Manual