Xerox C2424 - WorkCentre Color Solid Ink Service Manual page 153

Jam Code Troubleshooting Procedures
T2Q The exit door open flag unexpectedly tripped when the system picked from Tray 1.
T2R The exit door open flag unexpectedly tripped while the system was duplexing.
T2S The exit door open flag unexpectedly tripped while the paper was staging for the
transfix cycle.
T2T The exit door open flag unexpectedly tripped while the print was being transfixed.
T2X The exit door open flag unexpectedly tripped while the system was ejecting the
print.
T2Z The exit door open flag unexpectedly tripped while the system was shutting down.
1. Ensure the media is supported.
2. Ensure ground integrity of the system, see page 4-73.
3. Run the Monitor Sensors test.
4. Inspect the door switch for damage and proper operation.
5. Check the drum maintenance unit to ensure it is functioning properly and the
blade is not covered with ink debris.
6. Replace the drum maintenance unit.
7. Replace the transfix roller.
V2D Tray 2 media size sensor unexpectedly activated during warm-up.
V2E Tray 2 media size sensor unexpectedly activated during system ready.
V2F Tray 2 media size sensor unexpectedly activated while system was in a fault state.
V2K Tray 2 media size sensor unexpected event during oil transfix.
V2L Tray 2 media size sensor unexpectedly activated while the system was in standby.
V2M Tray 2 media size sensor unexpectedly activated while picking from Tray 2.
V2N Tray 2 media size sensor unexpectedly activated while picking from Tray 3.
V2P Tray 2 media size sensor unexpectedly activated while picking from Tray 4.
V2Q Tray 2 media size sensor unexpectedly activated while picking from Tray 1.
V2R Tray 2 media size sensor unexpectedly activated while Duplexing.
V2S Tray 2 media size sensor unexpectedly activated while paper staged for print.
V2T Tray 2 media size sensor unexpectedly activated while transfixing the print.
Error Messages and Codes
(Continued)
3-61