Programming An End Receiver - Ricoh 8025e Operating Instructions Manual

Programming an End Receiver

This section describes how to program an End Receiver.
Important
❒ One end receiver can be registered for each special sender. To register two or
more end receivers, use group destination. However, a maximum of 500 des-
tinations can be specified in a group.
A
Press [Facsimile Features].
B
Press [Administrator Tools].
C
Press [Forwarding].
D
Press [On].
If there is an End Receiver already programmed, a receiver name is shown. If
you want to change the receiver, press [Receiver] and proceed to step
To cancel Forwarding, press [Off]and proceed to step
E
Specify an End Receiver using the destination list, and then press [OK].
The receiver name is shown to the right of [Receiver].
Press the key on the right of the display to switch the destination between fax
number, e-mail address, IP-Fax destination, and folder.
Set a folder destination in Address Book Management under Administrator
Tools in the System Settings menu. See "Registering Folders".
If you have specified a folder for forwarding, you can specify the file format
used for forwarding. See "Parameter Settings" (switch 21, bit 3).
If you make a mistake, press [Clear] before pressing [OK], and then try again.
F
Press [OK].
G
Press the {User Tools/Counter} key.
Reference
p.125 "Parameter Settings"
p.217 "Registering Folders"
Forwarding
E
.
F
.
4
123