Ricoh 8025e Operating Instructions Manual page 227

S
Press [Exit].
Note
❒ To register the name, see Registering Names".
❒ You can enter up to 64 characters for the user name.
❒ You can enter up to 64 characters for the password.
❒ You can enter a path using up to 128 characters.
❒ To specify a folder, you can either enter the path manually or locate the
folder by browsing the network.
❒ If the connection test fails, check the settings, and then try again.
❒ When [Do not Specify] is selected, the SMB User Name and SMB Password
that you have specified in Default User Name / Password (Send) of File
Transfer settings applies.
❒ If User Authentication is specified, contact your administrator.
Reference
p.188 "Registering Names"
p.219 "Locating the SMB folder manually"
p.220 "Locating the SMB folder using Browse Network"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
A
Press [Change] under Path.
B
Enter the path where the folder is located.
C
Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit],
and then enter the path again.
Note
❒ Enter the path using this format: "\\ServerName\Share- Name\Path-
Name".
❒ You can also enter an IP address.
❒ You can enter a path using up to 128 characters.
Registering Folders
219
7