Switch Settings - Vodavi Starplus Triad-S Installation Manual

Caller ID Interface Unit Installation

Switch Settings

S1 dip switches select the signaling protocol of the RS-232 OUT
connector to assist in matching signals from the 1480-00 with those of
the DTE device. S2 dip switches control two major functions:
(UP)
(DOWN)
Figure 2-15 illustrates the connections for the TCI Caller ID Interface
Unit.
Triad-S™
KSU 9-Pin
Female
Figure 2-15: Caller ID Cable Connections
Switches 1-5 configure the 1480-00 to the DTE device for baud rate,
data bits, and parity.
Switches 6-8 select the unit number for the 1480-00 when multiple
units are connected in series. If a single unit is used, switches 6-8 are
set for Unit #1.
Set the switches on the 1480-00 as follows:
S 1
On
Off
1 2 3 4 5 6 7 8
MISU
1480-00 9-Pin
Male
2
5
7
8
1 2 3 4 5 6 7 8
S 2
2-29