Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
The thread trimming button was
pressed while a screen other than
the embroidering screen or
embroidering settings screen was
displayed.
Display either the embroidering
screen or embroidering settings
screen before using the thread
trimming function.
The thread trimming button was
pressed before the machine was
unlocked.
Touch
trimming function.
The machine is retrieving a
previously saved pattern.
Thread guide assembly support is
not prepared.
Prepare the thread guide assembly.
(Refer to "Preparing the thread
guide assembly" on page 30.)
The machine needs maintenance.
(Refer to page 283.)
to use the thread
The machine was stopped while
the needle bar case was moving.
Touch
reset the needle bar case.
Machine failed to communicate
with the PC in the Link mode.
Turn off the machine, and on
again.
Machine has recognized the
embroidery position mark.
Remove the embroidery
positioning sticker and touch
The combined character pattern is
too large for the embroidery
frame.
to automatically
Rotate the pattern 90 degrees and
then continue combining
characters.
to continue.
Troubleshooting 297
7
Advertisement
Table of Contents
Troubleshooting
